Click to buy RP RV1103 Core Board now > >
Main hardware index | |
Size | 40mm length * 30mm width * 2.8mm height |
Connection mode | Stamp hole |
CPU | ROCKCHIP RV1103 mono-core A7+MCU |
NPU | 0.5 TOPS |
Memory | Built-in DDR2 64MB |
Storage device | Standard 128MB for SPI FLASH |
Power management | Design of discrete power supply |
Working voltage | 3.4V-5.5V 400mA or above |
Support system | Linux5.10.66 |
Operating temperature | -10 to + 75 degrees |
Common interface of core board | |
USB interface | All the way to OTG port |
UART serial port | 4-way UART, one of which is Debug |
GPIO interface | 40-way GPIO (Note: with multiplexing function, please check the pin definition in this specification) |
PWM interface | 12 PWM have 3.3V/1.8V level respectively (please check the pin definition in this specification) |
MIPI camera interface | 2-way MIPI CSI camera interface (supports LVDS format) |
Voice output | 1 channel left channel output, backplane can be connected with power amplifier |
Voice input | 1-way analog MIC input |
SDIO interface | 2 SDIO interfaces, one TF card, the other can be connected to WIFI |
ADC interface | 2 ADC interfaces (one upgrade port) |
I2C interface | 2-way I2C interface |
SPI interface | 1-way SPI interface |
Ethernet | One hundred megabit Ethernet |
System upgrade | Support for local USB upgrades |
Hardware function | Busybox linux 5.10.66 |
Tcpy-c (5V power supply) | √ |
MASKROM button (upgrade button) | √ |
RECOVERY button | |
SDIO AP6212 WIFI | √ |
Ethernet 10M/100M | √ |
SPK | √ |
MIC (microphone) | √ |
DEBUG | √ |
UART3 | √ |
RTC | √ |
USB2.0 x2 | √ |
USB2.0 (pin) | √ |
4G module expansion | √ |
SIM | √ |
MIPI CSI (gc2093) | √ |
TF | √ |
NCA9555 (gpio extension) | √ |
Bus driver | |
ADC driver | √ |
PWM driver | √ |
SDIO driver | √ |
GPIO driver | √ |
USB driver | √ |
Can driver | √ |
I2s drive | √ |
I2C drive | √ |
Spi driver | √ |
Project | Minimum | Typical | Maximum | |
Power supply parameters | Voltage | 4.5 | 5V | 5.5V |
Ripple | -- | 50mV | ||
RTC (HYM8563) | 0.3uA | 0.9uA | 1.2uA | |
Current test with backplane | Power-on current | 31mA | 62mA | 155mA |
Desktop static current | 68mA | |||
Environment | Relative humidity | -- | 65% | 75% |
Operating temperature | -10 ℃ | -- | 75 ℃ | |
Storage temperature | -30 ℃ | -0 ℃ | 100 ℃ |
Click to buy RP RV1103 Core Board now > >
Main hardware index | |
Size | 40mm length * 30mm width * 2.8mm height |
Connection mode | Stamp hole |
CPU | ROCKCHIP RV1103 mono-core A7+MCU |
NPU | 0.5 TOPS |
Memory | Built-in DDR2 64MB |
Storage device | Standard 128MB for SPI FLASH |
Power management | Design of discrete power supply |
Working voltage | 3.4V-5.5V 400mA or above |
Support system | Linux5.10.66 |
Operating temperature | -10 to + 75 degrees |
Common interface of core board | |
USB interface | All the way to OTG port |
UART serial port | 4-way UART, one of which is Debug |
GPIO interface | 40-way GPIO (Note: with multiplexing function, please check the pin definition in this specification) |
PWM interface | 12 PWM have 3.3V/1.8V level respectively (please check the pin definition in this specification) |
MIPI camera interface | 2-way MIPI CSI camera interface (supports LVDS format) |
Voice output | 1 channel left channel output, backplane can be connected with power amplifier |
Voice input | 1-way analog MIC input |
SDIO interface | 2 SDIO interfaces, one TF card, the other can be connected to WIFI |
ADC interface | 2 ADC interfaces (one upgrade port) |
I2C interface | 2-way I2C interface |
SPI interface | 1-way SPI interface |
Ethernet | One hundred megabit Ethernet |
System upgrade | Support for local USB upgrades |
Hardware function | Busybox linux 5.10.66 |
Tcpy-c (5V power supply) | √ |
MASKROM button (upgrade button) | √ |
RECOVERY button | |
SDIO AP6212 WIFI | √ |
Ethernet 10M/100M | √ |
SPK | √ |
MIC (microphone) | √ |
DEBUG | √ |
UART3 | √ |
RTC | √ |
USB2.0 x2 | √ |
USB2.0 (pin) | √ |
4G module expansion | √ |
SIM | √ |
MIPI CSI (gc2093) | √ |
TF | √ |
NCA9555 (gpio extension) | √ |
Bus driver | |
ADC driver | √ |
PWM driver | √ |
SDIO driver | √ |
GPIO driver | √ |
USB driver | √ |
Can driver | √ |
I2s drive | √ |
I2C drive | √ |
Spi driver | √ |
Project | Minimum | Typical | Maximum | |
Power supply parameters | Voltage | 4.5 | 5V | 5.5V |
Ripple | -- | 50mV | ||
RTC (HYM8563) | 0.3uA | 0.9uA | 1.2uA | |
Current test with backplane | Power-on current | 31mA | 62mA | 155mA |
Desktop static current | 68mA | |||
Environment | Relative humidity | -- | 65% | 75% |
Operating temperature | -10 ℃ | -- | 75 ℃ | |
Storage temperature | -30 ℃ | -0 ℃ | 100 ℃ |