Main hardware indicators | |
size | Length 69.6mm x Width 45mm x Height 4.8mm |
CPU | Ruichip RV1126 quad-core main frequency 1200MHz |
NPU | 2.0 TOPS NPU |
Memory | DDR4 standard 1G (2G batch optional) |
memory | eMMC standard 8G (4G/16G/32G/64G batch optional) |
power management | RK809-2 supports dynamic power management |
Operating Voltage | Input voltage 5V, maximum power less than 2W (without any peripherals) |
support system | Linux 4.19 + QT 5.12 |
operating temperature | -10 to +75 degrees |
Core board common interface | |
USB interface | Two-way USB, one independent OTG, one independent HOST |
UART serial port | 6 channels of TTL 3.3V level, one of which is Debug |
GPIO interface | 98-way GPIO (remark: there is a multiplexing function, please check the pin definition in this specification) |
PWM interface | The 12 channels of PWM have 3.3V/1.8V levels respectively (please check the pin definition in this specification) |
MIPI DSI display | 1 channel maximum 1920x1080 60fps |
RGB display | 1 channel RGB 888 display interface, maximum 1920x1080 |
DVP camera interface | 1 channel 16-bit parallel DVP camera interface |
MIPI camera interface | 2-way MIPI CSI RAW data camera interface |
voice output | 1 left and right channel output, 10W power amplifier on the bottom board |
Voice input | 1 channel PDM digital silicon microphone input, 1 channel analog LANE_IN input |
SDIO interface | 2-way SDIO interface, one way TF card, the other way can be connected to WIFI |
IR infrared interface | 1 channel IR infrared receiving interface |
ADC interface | 6 ADC interfaces |
I2C interface | 5-way I2C interface |
SPI interface | 2 way SPI interface |
CAN | 1 channel CAN bus |
ethernet | One RGMII PHY interface, Gigabit Ethernet |
System Upgrade | Support local USB upgrade |
RV1126 function and driver support list | ||
function list | Linux kernel 4.19 | Linux kernel 4.19 |
hardware function | ||
RTC time saving HY8563 | √ | √ |
power button, power button | √ | √ |
Reset button | √ | √ |
Burn chain | √ | √ |
Function key ADC0 | √ | √ |
USB OTG device mode ADB | √ | |
USB OTG HOST mode | √ | √ |
USB HOST interface | √ | √ |
TF card up to 128GB | √ | √ |
Debug serial port 2 | √ | √ |
4-way functional serial port 1,3,4,5 | √ | √ |
5-way controllable GPIO | √ | √ |
5 ADC interfaces | √ | √ |
MIPI camera interface IMX307 | √ | √ |
MIPI camera interface binocular GC2093 | √ | √ (only monocular is supported for now) |
MIPI camera interface binocular GC2053+OV2718 | √ | √ (only monocular is supported for now) |
USB camera YVC | √ | √ |
Simultaneous preview of usb dual cameras | ||
MIPI display + touch screen up to 1920x1080 | √ | √ |
headphone output | √ | √ |
Speaker output (with headphone detection function) | √ | √ |
LANE IN two-channel voice input | √ | √ |
PDM digital silicon microphone | √ | √ |
SDIO wifi AP6256 5G dual band | √ | √ |
BT Bluetooth 5.0+BLE | √ | √ |
Gigabit Ethernet RTL8211F Adaptive 100/1000M | √ | √ |
4G communication EC20 | √ | √ |
reset | √ | √ |
WIFI hotspot | √ | √ |
body sleep wake up | √ | |
USB to serial port | √ | √ |
USB port | √ | √ |
WIFI miracase receiver | ||
Watchdog API calls | √ | √ |
driver list | ||
rk809-2 PMIC driver | √ | √ |
Ethernet RTL8211F driver | √ | √ |
SDIO WIFI+BT AP6256 driver | √ | √ |
UART serial driver | √ | √ |
MIPI display driver | √ | √ |
I2C touch screen driver | √ | √ |
RTC time saving driver | √ | √ |
EC20 driver | √ | √ |
SPI driver | √ | √ |
ADC driver | √ | √ |
I2C driver | √ | √ |
PWM driver | √ | √ |
SDIO driver | √ | √ |
GPIO driver | √ | √ |
USB drive | √ | √ |
project | the smallest | typical | maximum | |
Power parameters | Voltage | 6.5V | 12V | 15V |
ripple | <p style="margin-top: 1.12em; margin-bottom: | |||
Main hardware indicators | |
size | Length 69.6mm x Width 45mm x Height 4.8mm |
CPU | Ruichip RV1126 quad-core main frequency 1200MHz |
NPU | 2.0 TOPS NPU |
Memory | DDR4 standard 1G (2G batch optional) |
memory | eMMC standard 8G (4G/16G/32G/64G batch optional) |
power management | RK809-2 supports dynamic power management |
Operating Voltage | Input voltage 5V, maximum power less than 2W (without any peripherals) |
support system | Linux 4.19 + QT 5.12 |
operating temperature | -10 to +75 degrees |
Core board common interface | |
USB interface | Two-way USB, one independent OTG, one independent HOST |
UART serial port | 6 channels of TTL 3.3V level, one of which is Debug |
GPIO interface | 98-way GPIO (remark: there is a multiplexing function, please check the pin definition in this specification) |
PWM interface | The 12 channels of PWM have 3.3V/1.8V levels respectively (please check the pin definition in this specification) |
MIPI DSI display | 1 channel maximum 1920x1080 60fps |
RGB display | 1 channel RGB 888 display interface, maximum 1920x1080 |
DVP camera interface | 1 channel 16-bit parallel DVP camera interface |
MIPI camera interface | 2-way MIPI CSI RAW data camera interface |
voice output | 1 left and right channel output, 10W power amplifier on the bottom board |
Voice input | 1 channel PDM digital silicon microphone input, 1 channel analog LANE_IN input |
SDIO interface | 2-way SDIO interface, one way TF card, the other way can be connected to WIFI |
IR infrared interface | 1 channel IR infrared receiving interface |
ADC interface | 6 ADC interfaces |
I2C interface | 5-way I2C interface |
SPI interface | 2 way SPI interface |
CAN | 1 channel CAN bus |
ethernet | One RGMII PHY interface, Gigabit Ethernet |
System Upgrade | Support local USB upgrade |
RV1126 function and driver support list | ||
function list | Linux kernel 4.19 | Linux kernel 4.19 |
hardware function | ||
RTC time saving HY8563 | √ | √ |
power button, power button | √ | √ |
Reset button | √ | √ |
Burn chain | √ | √ |
Function key ADC0 | √ | √ |
USB OTG device mode ADB | √ | |
USB OTG HOST mode | √ | √ |
USB HOST interface | √ | √ |
TF card up to 128GB | √ | √ |
Debug serial port 2 | √ | √ |
4-way functional serial port 1,3,4,5 | √ | √ |
5-way controllable GPIO | √ | √ |
5 ADC interfaces | √ | √ |
MIPI camera interface IMX307 | √ | √ |
MIPI camera interface binocular GC2093 | √ | √ (only monocular is supported for now) |
MIPI camera interface binocular GC2053+OV2718 | √ | √ (only monocular is supported for now) |
USB camera YVC | √ | √ |
Simultaneous preview of usb dual cameras | ||
MIPI display + touch screen up to 1920x1080 | √ | √ |
headphone output | √ | √ |
Speaker output (with headphone detection function) | √ | √ |
LANE IN two-channel voice input | √ | √ |
PDM digital silicon microphone | √ | √ |
SDIO wifi AP6256 5G dual band | √ | √ |
BT Bluetooth 5.0+BLE | √ | √ |
Gigabit Ethernet RTL8211F Adaptive 100/1000M | √ | √ |
4G communication EC20 | √ | √ |
reset | √ | √ |
WIFI hotspot | √ | √ |
body sleep wake up | √ | |
USB to serial port | √ | √ |
USB port | √ | √ |
WIFI miracase receiver | ||
Watchdog API calls | √ | √ |
driver list | ||
rk809-2 PMIC driver | √ | √ |
Ethernet RTL8211F driver | √ | √ |
SDIO WIFI+BT AP6256 driver | √ | √ |
UART serial driver | √ | √ |
MIPI display driver | √ | √ |
I2C touch screen driver | √ | √ |
RTC time saving driver | √ | √ |
EC20 driver | √ | √ |
SPI driver | √ | √ |
ADC driver | √ | √ |
I2C driver | √ | √ |
PWM driver | √ | √ |
SDIO driver | √ | √ |
GPIO driver | √ | √ |
USB drive | √ | √ |
project | the smallest | typical | maximum | |
Power parameters | Voltage | 6.5V | 12V | 15V |
ripple | <p style="margin-top: 1.12em; margin-bottom: | |||